Tried to extend rafter lengths using Push/Pull. This is extending horizontally. How do I extend on the same plane as the rafter…?
Sketchup 2017 Make
Skip…608 Linda Lane_Purged.skp (619.3 KB)
Tried to extend rafter lengths using Push/Pull. This is extending horizontally. How do I extend on the same plane as the rafter…?
Sketchup 2017 Make
Skip…608 Linda Lane_Purged.skp (619.3 KB)
Push/Pull is supposed to extrude perpendicular to the face. Don’t use Push/Pull. Select the end face of the Rafter and use Move.
Which end of the rafter are you trying to extrude?
It would be a good idea to put off adding materials until you have the geometry complete.
Thanks
Skip…