Cant make rounded corners and use push pull. Can you help please?

I have one last question if you don’t mind Box,I don’t want to be a nuisance but if I wanted to create the same curve around the bottom edge of the box is this easy to do? I had a bit of a go at it. drew lines 3mm in underneath and radius curves around the bottom edge but when I erased the corners the whole edge disappears. Obviously I’m doing something wrong

There are a few ways to do what you want, follow me being the vanilla way, Round Corner By Fredo being the Plugin way.
Either way you need to scale up to avoid tiny face issues.

Here is one way using follow me, note I scale up by 10 to begin, the down by .1 at the end.

Terrific! Easier than I thought it would be. Thank you once again Box. Regards… Ronnie.

This topic was automatically closed 91 days after the last reply. New replies are no longer allowed.