Spacing on chess pieces when using followme?



I am a student trying to learn sketch up. I am trying to make a 3d chess board however some of my chess pieces have spacing where they are supposed to join. I have tried redoing all of them to fix the issue but it keeps happening especially with the bishop.

Any advice will help :slight_smile:


Could you upload the SKP file?


It says “Sorry, the file you are trying to upload is too big (maximum size is 3072KB).”


You should use the followme like this.


You get a better result by preselecting the path. Also the bottom will fill in if it isn’t touching the circle.


Uploading… This 100% fixed all the issues. The circles were messing with the shapes so moving them down made a huge difference. :smile: thank you!


@Box, you have an amazing gift for the gif.


This topic was automatically closed 91 days after the last reply. New replies are no longer allowed.