Sliding Dovetail Saw (#1).skp (335.4 KB)
An old article was posted in the Fine Woodworking site about this saw written by Tage Frid. I took a screenshot of the diagram and made this model of the saw after scaling and tracing over the screenshot.
An old article was posted in the Fine Woodworking site about this saw written by Tage Frid. I took a screenshot of the diagram and made this model of the saw after scaling and tracing over the screenshot.
2 Likes
Sliding Dovetail Saw (#2).skp (439.9 KB)
I redid this to round over the sharp edges of the handle. At first I tried to edit the handle and champher the edges. Because of the curves, I just made a mess. I started over, traced over the skp, made two copies an inch apart, used a quarter circle of an inch diameter, and used that to form the circular outline. I used entity info to reduce the number of segments in all the arcs from 12 to 3 to 5 segements. That made it easy to make a solid handle. It was like making a conestoga wagon. Rotate/copy quarter circles, connect the dots to make faces, flip move to complete the arc on the other side.
1 Like