Wall on multiple planes, Push/Pull error? Noob

I think I have this under the right topic section.
I’m not sure how I created this mess. I know I had lines that were part of a different component, but after redrawing multiple lines, I have this issue.


New drawing and layout.skp (11.7 MB)
I’m new and self taught, and I’m sure that I haven’t been using layers and tags incorrectly. Thanks for any advice or help I can get.

you have a lot of hidden lines.

just edit / reveal / all
then clean all the extra lines and when you’re done, close the wall properly again.

where is the file from, archicad ? revit ? (I remember seeing some weird triangulation when importing archicad files)


in the web version it’s in the display menu on the right.

You also have a lot of tagged “raw” geometry and almost no groups or components. Leave all edges and faces untagged, group all logical parts of your model and add tags to these groups or components.

Thanks so much! That corrected it. It was a lot of lines for sure. I created it all in Sketchup web. I’m not sure what I did to create the mess…