Why my sketchup pro 2021 keep crashing when I’m using flowify. My 3d not so complicated I guess. Anyone can help?
here the 3d model, if anyone can help to check. Thanks!
lattice test 1.skp (2.4 MB)
Does it actually crash or are you too impatient to wait for it to finish.
It worked ok, given time, on mine.
But consider the design, you could do one row, then flip it and create an array.
i waited, but after few sec it will crash and close the skecthup.
Try updating your graphic card driver.
Or as I mentioned above, try just doing one row.
Okeyy, Thanks for help!!