I didn’t have time yesterday to elaborate on what I meant about using layers for plans, but I had a minute now.
Rather than chopping your Images you can assign them a visibility layer that allows you to turn them on and off. As you see here, I dig down to the actual image and assign it to the layer I have called plans, then dig down again to the other image and add that too.
You can also assign Groups and Components to layers and turn them on and off. As long as you have grouped or componented your walls etc you can have a layer for Ground Floor, First Floor etc…
But don’t try putting raw geometry on any other layer than Layer0, and always leave Layer0 as the active layer, in other words never touch the black dot to the left of the layer name, until such time as you really understand why you want to do it, there are a very few reasons why you would.
2 Likes