Help with Starship Trooper 3D model

SketchUp 3D Printing
1

Hi
Im new to the SketchUp and the community . Im currently working on a Starship Trooper Cosplay Build. I have been able make all the parts and print them except for the one I have uploaded. Im having the hardest time getting it to be a solid object. I have run solid inspector2 on it and it says that everything is good. But its still not registering as a solid. Any help would be greatly appreciated!

Thanks!

morita 2.zip (2.3 MB)

2

There seems to be a tiny face reversed.
Tiny%20face%20right%20here

Shep

1 Like
3

You might wanna check this post, too:

1 Like
4

Thanks so much for the help. I would have never found that. How did you? Is it something else like Solid Inspector2?

Thanks again for the help.

5

when you run solid inspector it should highlight in red the problem. Sometimes going into wireframe mode can make it easier to see.

6

… and with Solid inspector you can use the tab key to jump from one error to the next and zoom to it.

1 Like
7

As haskill noted, solid inspector didn’t detect this error.
I just removed parts of the model to narrow down where to look. It only took a couple tries.

Shep