Cutting off excess curve

[jean_lemire_1]

This is the same picture that you showed in this other thread:

Sketchup - how to draw a custom arc

Hi, I’m trying to layout a curved range hood. I have attached an example of the concept. In my drawing I have set some fixpoints that the arc needs to pass through and used the 2 point arc tool to create the arc. But as you can see, the arc does not pass through the fixpoints. I then tried to make individual arches between each of the points, but that results in an arc with several small ‘high’ points where the curved sections meets, and I found no way to smooth the transition. So that is no…