Sketchup 2019 Feature Requests

[sjdorst]

@betazero

Non destructive subtractive modeling

I started a “pre feature request” thread on this a couple of years ago.

Brainstorm idea of a "negative space" component

I’ve had a bit of a brainstorm, and before I add this idea to the “Feature Request 2017” thread, I’m hoping to thresh it out a bit here. I’m thinking there might be a good case for a special type of component: one that defines negative space. As I envision it, it would only make sense if it meets the criteria for a “solid”. In use, however, it would always (?) need to be embedded in a enclosing component/group. I’ve seen quite a few threads there people want to make a lot of identical holes. E…

Some of the replies are hard to understand because one contributor to the thread - who did valuable stuff - decided to take his marbles and leave the forum - after deleting ALL his content!