Sorry to bother again but I have been struggling a lot with this.
I have finally fixed the problem with the changing of the angled part with a locked LenY-value for Corner LenY.
So that is ok now I hope. Thank for the help with that part.
My problem now is the total lenght of the complete board component.
I have used the information in the link above but tried to simplify since I don’t need to change the size of the board.
As shown in the screenshot below the total lenght is the LenY-attribute under Ytterpanel (4.582 cm)…
As shown from the dimensions this s not the accurate lenght. It should be approx. 9.7 cm.
The lenght of the corner part is locked to 6.194 cm (LenY) to avoid the part to change
When I change the lenght of the board with the scale tool the Ytterpanel LenY is updated but still incorrect.
I will need this correct lenght for a report with the total used lenght of boards.
So my first question is
Why is not Ytterpanel LenY correct?
Storlek = Size
