Unable to locate a "surface border" error


#1

I’m down to just one “surface border” error flagged by Solid Inspector 2. At the moment it has no volume, so I don’t think it will print as a solid part. I have scaled it up to 1000 times it actual size, but still can’t see any hint of a problem when I roam around the part. Is there any way to determine the location of the error? The part sits on a base (which is “Shiny”), but the file was too big to attach so I ditched the base.


#2

The Tab key will highlight the error for you.


#3

This topic was automatically closed after 91 days. New replies are no longer allowed.