Simple model does not print - hole is filled in!

I’m a fairly new Sketchup user - I’ve had very few problems, but this one confuses the heck out of me. I have a small dome that has a hole in the top - when I look at it in Sketchup it looks great, when I put it into Cura it looks great. But when it prints it has no hole in the top of the dome!!! Any ideas?

Button4.skp (1.3 MB)

It doesn’t create a solid component/group. Solid Inspector2 most of the reasons why.

In addition, there’s a bad spot on the bottom edge.

Button4.skp (1.3 MB)

Solid Inspector is awesome - thanks for both looking at the model and mentioning what is now my new favorite extension!

This topic was automatically closed after 91 days. New replies are no longer allowed.