Push Pull Through 2 Curves at Right Angles

Hello All,

I’ve tried push-pull, follow me, and the joint push-pull extension, but no luck. I’ve found some threads that were close to what I needed, but couldn’t make the suggestions there work for me.

I’m trying to push two curves through each other at right angles and can’t find a way to do it.

The section marked with red needs to go, but only down to the curve that I’m pushing above.

Thanks!

Tap ctrl when you hit it and it will continue through, then use intersect faces to clean up.

2 Likes

Awesome, thanks! I knew about creating a new face, but I didn’t know that’s what Intersect Faces would do. Makes sense when I think about it! :slight_smile:

Made a demo so I’ll post it anyway for others who ask.
Push through

2 Likes