Making the model solid (again)

[ned.reif]

I followed the advice here

Making the model solid

My model was grouped by several solid groups, but I decided to make the whole model a single solid group. I removed all the faces in between when I exploded everything and it seemed like I removed all of them, when I went on to check with Solid Inspector it gave me the message ‘‘1 Surface Borders’’, but it doesn’t show where it is. Only that surface (which I cannot find) separates the group to become a solid. [Screenshot_2]

i.e. I turned on the xray vision, but I still can’t see a red line.
Please tell me that my eyes are not going bad…
Oscar v053.skp (580.2 KB)

[DaveR]

After Solid Inspector identifies the problem, hit Tab to go to it. It’s on the bottom of the group so orbit the camera low so you’ll see it.

[ned.reif]

Thanks! Sages know such nifty shortcuts that really help us beginners.

[ned.reif]

[Box]

@ned.reif

Sages know such nifty shortcuts that really help us beginners.

One key to our omniscience is reading the bottom of the screen.