# How to create curve on an angle AKA push pull curved surface

**URL:** <https://forums.sketchup.com/t/how-to-create-curve-on-an-angle-aka-push-pull-curved-surface/81888>\
**Category:** SketchUp\
**Created:** [November 23, 2018, 9:00pm UTC](https://forums.sketchup.com/t/how-to-create-curve-on-an-angle-aka-push-pull-curved-surface/81888 "2018-11-23T21:00:43Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![DoubleHelix](https://avatars.discourse-cdn.com/v4/letter/d/90db22/32.png) [@DoubleHelix](https://forums.sketchup.com/u/DoubleHelix)\
**Post date:** [November 23, 2018, 9:00pm UTC](https://forums.sketchup.com/t/how-to-create-curve-on-an-angle-aka-push-pull-curved-surface/81888/1 "2018-11-23T21:00:43Z")

</div>

From the file attached i have a corner, what would be the best way to keep that angle and fill the curve?[Sketchup scale 2.skp](https://forums.sketchup.com/uploads/short-url/tLZCVLnyE6w2O9BjQurcSnmjVMP.skp) (139.3 KB)

---

<div class="post-metadata">

**Author:** ![DoubleHelix](https://avatars.discourse-cdn.com/v4/letter/d/90db22/32.png) [@DoubleHelix](https://forums.sketchup.com/u/DoubleHelix)\
**Post date:** [November 23, 2018, 10:20pm UTC](https://forums.sketchup.com/t/how-to-create-curve-on-an-angle-aka-push-pull-curved-surface/81888/2 "2018-11-23T22:20:19Z")

</div>

Solved.

This saved allot of time.

> **[SketchUp Plugins | PluginStore | SketchUcation](https://sketchucation.com/pluginstore?pln=JointPushPull)**
>
> SketchUp Plugin and Extension Store by SketchUcation provides free downloads of hundreds of SketchUp extensions and plugins

---

<div class="post-metadata">

**Author:** ![whiterabbitdesigncompany](https://sea2.discourse-cdn.com/sketchup/user_avatar/forums.sketchup.com/whiterabbitdesigncompany/32/84739_2.png) [@whiterabbitdesigncompany](https://forums.sketchup.com/u/whiterabbitdesigncompany)\
**Post date:** [November 23, 2018, 10:40pm UTC](https://forums.sketchup.com/t/how-to-create-curve-on-an-angle-aka-push-pull-curved-surface/81888/3 "2018-11-23T22:40:55Z")

</div>

Not sure if that front lower edge should be sloping or if the whole bottom face should be on a single plane? ( the red wiggly line over that black line is a line that should be red?  
I tried joint push pull but because of the top slope it didnt seem to work.  
I used find centre arc (or offset) to get curved edges and then used the curviloft / skin contours on each face.

 ![corner](https://global.discourse-cdn.com/sketchup/original/3X/d/8/d8b653fcb8f4627e66bd3a56dc07974c930a3749.jpeg)