Inspired by a post I saw earlier, I’ve installed the Fredo-Scale toolset. These are done with the taper, bend and twist tools. I’m sure there’s much more can be done with these, but just having some fun at the moment.
5 Likes
Another tinker with just the twist tool this time, the left two are made of five separate components which were twisted and then stacked on top and rotated to the correct alignment with the component below. I’ve found I can achieve different results depending on: PROFILE vs COMPONENT HEIGHT vs ANGLE OF TWIST.
I know this is old hat to some but it’s fun just to tinker with different methods, 
2 Likes