It’s me again. Sorry. I’m almost finished with my first model, first floor with exterior porches and I’m trying to create a fence post cap, but I can’t figure out how to make the center point of the X pull up without bringing everything else with it. Thank you.
Porch_rail.skp (96.4 KB)
Use the Move command. With nothing selected (if nothing is selected, Move will allow you to select a point to move), activate Move, and hover over the middle point. Then click and move straight up.
Also, if the top is a component or group make sure that it is open for edit!
OMG! Was that simple and easy! Thank you both! 
This topic was automatically closed 91 days after the last reply. New replies are no longer allowed.