Inserting a sink into a counter top

[Gully_Foyle]

See this previous thread:

Why is my "cutting" component not cutting?

As part of a project I’m modeling - envisioning a “group” (not commercial) kitchen - I ran into problems with the complexity of the model. Specifically, the only “hotel” pans I could find in the 3DW had far too much geometry and were slowing down my model considerably. So I created my own component: 1_4x400_Hotel_Pan_Cutting.skp (42.8 KB) which is a compromise between appearance and geometry count (original was almost 9000 in it’s geometry count!) When I first created it, it successfully cut …

-Gully