Any quick way to round several intersections between two arcs or arc and line?

[DaveR]

@spawn

Do you have all extensions and plugins toolbar visible or you just turn them visible if you think you’re going to use them?

Some I leave displayed all the time. Some I bring out when I need them. You can see the way my normal working screen is lair out in this post.

How do I heal this miter on cabinet door frame?

Think about how you would make that in the shop. You’d run the cutter off the end. At the point you’re at now, Hit Ctrl with Push/Pull and run the round over profile off the end a ways. Then select all of the geometry and use Intersect Faces>With Selection followed by deleting the waste. If I were drawing that, though, I would do the profile along the length of the rail before coping the ends. [Untitled Project]

I use a simplified layout for most tutorial videos I do.